Search results

Check the bearing shells ... and the vanos. Bearing shells tends to be tricky if it's the problem. You have to create a matrix to calculate next steps.

Monitor the oil pressure - benchmark how far its away from setpoint. Use BMW LL01 EO so that viscosity do not mess up the pressure Monitor for sounds coming from the vanos If doing a VCG - use the opportunity to check the vanos bolts torque and torque to yield specs are correct.

It's the injectors. The n20 injectors tends to be noisy over time ...

You need to change the vehicle configuration and code it into the ride as well if the battery type is modified. A reset alone will not suffice. A registration is also needed - get the mileage recorded into the DME for the battery change. This has an influence on the charging cycle. The...

Did you bed in the pads ?

Follow the recommended schedule and it should be trouble free ...

Congrats ...

Usually there would be a shadow code ... Don't clear it off.

Any black smoke or lots of carbon deposits on the tailpipe ?

K-Sport rear BBK allows the stock EPB actuator to be integrated.

With electronic parking brake - changing to Brembo or AP rear calipers would give a fault code.

If it continuously jerks while stepping on the accelerator then it may not be the gearbox. Gearboxes jerk during a gear shift ... They should be referring to the mechatronics. Valvetronic is related to the engine intake valve system.

The contact switch is faulty .... tact

Have you tried reformatting the sd card ? or take the card out altogether and see how it reacts ?

Check settings ...

I had to deal with some personal matter at home and was not able to attend to Bro Gamemanlee the last 2 days ... Cylinder 6 had a compression and cylinder leak down test done. That cylinder was not able to hold compression when benchmarked against the other 5 cylinders. We could also hear the...

About the window - encountered a couple of times where it will not roll up or down after some repairs. It just has to be reinitialised with some scripts - one of those nuances that I cannot explain why but it happens. Same thing with some blown light bulbs ... it will never light up till I run...

If it's the oil pump - did they measure the oil pressure ? What about the vanos valve timing ? Sent from my iPhone using Tapatalk

Hi - it needs to be coded to have that show up on the iDrive ... Contact me @ 98006232 if you need to get it done.

In that case I could recode the module and clean up the fault.