john5017;n1844181 said:Hi extremeOH, I had not used any other in-vehicle cameras before so I can't help much when it comes to making comparisons.
After more than 6 months of use, I can provide the following feedback:
1) Once in a long while, the camera unit feedbacks that the rear camera is not attached and that I need to check the connections. It goes away after the car is restarted. When I sent my car back to service centre, the service staff acknowledged my concerns but were unable to find any faults with the connections since it is intermittent.
2) As it is positioned closer to the co-passenger's side of the windscreen, it is susceptible to log an event when the left door is closed with the same force applied to another other doors.
3) Using the default memory card provided and the recordings fill it up quickly. Once it is filled, the camera unit complains that the disk require a defrag every time I turn on the engine of the car. A simple card format via the screen removes this bothersome message but it comes back when the disk is full and its contents get over-written all over again.
4) Tried viewing the contents via the software provided. The whole setup process was easy. Quality of the image captured is above average in my opinion.
Good luck with your purchase
extremeOH;n1844194 said:Thanks John5017 for your honest feedback. Frankly I thought for that price, it should be problem free. I guess I might just go for iroad v9, which is half the price.
New5;n1844518 said:Since iroad V9 was mentioned, let me share my experience. The camera works very well and resolution is very very clear for front and back! But, gadget somehow cannot works well with BMW smart system. I tried the park mode - record when there is motion detected. There is a restarting problem on the gadget when this mode is activated. Gadget was not able to start up when engine starts and voltage charged above the setting. The gadget works well with the cut off command, when the batt is low (car is parked and engine is off), gadget will be cut off automatically. This allow car to have enough Volt to start up. BMW smart system will prompt nearly every morning that gadget is disconnected when car batt V drop below setting (u can set this Voltage) and error sign lights up at dashboard, a bit irritating.
So, now I use only the drive mode, means starts recording when car starts up and stop when engine switch off. Cant record when stationary parked (park mode).
If anyone else has similar V9 installed, may be can share their experience...cheers.
Booked appointment to fix up the advance car eye next week, any advice from experienced bros out there?
Hi extremeOH, I had not used any other in-vehicle cameras before so I can't help much when it comes to making comparisons.
After more than 6 months of use, I can provide the following feedback:
1) Once in a long while, the camera unit feedbacks that the rear camera is not attached and that I need to check the connections. It goes away after the car is restarted. When I sent my car back to service centre, the service staff acknowledged my concerns but were unable to find any faults with the connections since it is intermittent.
2) As it is positioned closer to the co-passenger's side of the windscreen, it is susceptible to log an event when the left door is closed with the same force applied to another other doors.
3) Using the default memory card provided and the recordings fill it up quickly. Once it is filled, the camera unit complains that the disk require a defrag every time I turn on the engine of the car. A simple card format via the screen removes this bothersome message but it comes back when the disk is full and its contents get over-written all over again.
4) Tried viewing the contents via the software provided. The whole setup process was easy. Quality of the image captured is above average in my opinion.
Good luck with your purchase
Hey, like to check with you. How do you fix that irritating defragmentation issue? I just got my car 2 weeks ago and am already hearing this whenever I start my engine. Do I just format the SD on the cam? Is there a perm fix? Thks